| |
Set Hotronix at 340 or
365 degrees.
(other machines at 350 or higher)
Pressure Med/Firm 6-8
Allow for warm up time. |
 |
Preheat
Bottom Pad
Before
applying, lock the top platen down for
60 seconds. This helps the ink to flow
properly during the application. |
NOTE:
These recommended time, temperature and pressure
settings are for Stahls' Hotronix® heat
seal machines. Settings on other heat presses
may vary based on their inconsistencies.
For Application on
cotton, polyester or poly/cotton blends. |
|
| |
| 1. |
Preheat
Garment |
 Place
garment on platen and press for 3-5 seconds
or until there is no more steam to remove wrinkles
and moisture. Check to be sure there are no
obstructions such as buttons, pockets or seams.
If there are, raise print area only with a
Print Perfect pad or mouse pad. |
|
| 3. |
Press |
 Close
the machine and press.
340 Degrees for 8 seconds
or
365 degress for 4 seconds. |
|
| 2. |
Position |
 Position
on garment
ink side down. |
|
| 4. |
Peel |
 Open
machine, pause 5 seconds and peel. |
|
|
|
